Say goodbye to the hassle of drilling holes in your mast with our One-Piece Aerofoil Spreader Kit. This innovative kit allows for easy installation and removal, making rig storage a breeze. Available in 5-degree sweep back options, and a standard length of 60mm, the spreaders come with holes pre-drilled in 5mm increments, allowing you to trim to your preferred length with ease.

Designed with an aerofoil section, these spreaders drastically reduce windage compared to traditional round-section spreaders, offering comparable stiffness with significantly less drag. The drag is reduced by approximately 90% for the same thickness of the spreader bar, improving your rig's overall performance. Perfect for sailors seeking efficiency and simplicity in their rigging setup.

Mast section, high tensile. 11mm dia / 1900mm length. 

Stainless steel back stay crane. 

Main sail head board wire, fits into mast plugs.

Corrector weight specifically designed to fit inside 11 mm round mast. Each weight is 10 grams.  The 9.6 mm diameter fits inside most nominal 11mm dia round masts. Nickel plated to help reduce corrosion.

Cost is per weight.

Hook, laser cut (small). Laser cut from 1.4 mm stainless steel sheet, 15 mm x 7 mm. The hole is de-burred to avoid wear on the line and the hook is then tumbled to smooth the cut edges.

Cost per hook.

Hooks - wire. Formed from 1.2 mm Ø stainless steel wire, 15 mm x 6 mm, 5/pack.

Rigging screw - M3. Single end design, nickel plated brass, M3 thread, self locking design, 1.2 mm Ø stainless steel wire. This self locking rigging screw can be used in a NON SELF LOCKING mode by removing the O ring. Add a normal M3 nut or a Nyloc self locking nut as preferred to provide the lock nut function.

The Head Fitting is designed for 11mm Ø round mast tubes and the 11.1mm alloy GROOVY mast section, making it a perfect fit for IOM, and similar-sized boats. The fitting provides a seamless attachment to your rigging, ideal for sailors looking for a high-quality, easy-to-install solution for their mast setup.

Backstay crane, stainless steel with multiple attachment points for the backstay.

Formed from 1.2 mm Ø stainless steel wire, 15 mm x 6 mm, 10/pack. Hole is in the same plane as the hook.

Rigging screw - M2.5. Single end design, nickel plated brass, M2.5 thread, self locking design, 1.2 mm Ø stainless steel wire. This self locking rigging screw can be used in a NON SELF LOCKING mode by removing the O ring. Add a normal M2.5 nut or a Nyloc self locking nut as preferred to provide the lock nut function.